Instructions

Before using the product, adjust the pH value of the water to approx. 6.8 with the product Cranit pH plus/Cranit pH minus. Mix the necessary dose of the product in 10 liters of water in a plastic container, start the filter device and slowly pour it into the collector (skimmer) or spread it evenly over the surface. Allow the filtration to run for several hours so that the product is perfectly mixed in the water, and then let it stand (with the filter device turned off) for about 10 hours. After this time, any precipitated dirt settled on the bottom of the pool can be sucked off with a submersible vacuum cleaner.

Dosage

3 – 6 ml of the product per 1 m³ (1,000 liters) of water.

Hazard identification

Signal word: DANGER

H318 Causes serious eye damage.

P101 If medical attention is needed, have product container or label at hand.
P102 Keep out of reach of children.
P234 Keep only in original container.
P280 Wear protective gloves/protective clothing/safety glasses/face shield.
P305+P351+P338 IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if worn and if they can be removed easily. Continue rinsing.
P310 Call a doctor immediately.
P302+P352 IF ON SKIN: Wash with plenty of water.
P501 Dispose of contents/container at a municipally designated hazardous waste disposal site.